Sensors3.conf for Asus M3N-HD/HDMI Motherboard

February 11th, 2009

As the motherboard database in seems to be broken, here’s the sensors3.conf file I use for my recently bought Asus M3N-HD/HDMI motherboard:

# Minimal sensors3.conf for Asus M3N-HD/HDMI motherboard
# Leszek Koltunski, 09 Feb 2009

chip “acpitz-virtual-*”

# this is the same as the temperature in
# /proc/acpi/thermal_zone/THRM/temperature
label temp1 “Thermal Zone”

chip “it8716-*”

# Voltages

label in0 “VCore”
label in1 “VDDR” # Not in BIOS
ignore in2
label in3 “+5V” # VCC
label in4 “+12V”
ignore in5 # -12 V not monitored
ignore in6 # -5 V not monitored
label in7 “5VSB” # Not in BIOS
label in8 “VBat” # Not in BIOS

# Vcore, VDDR, and Vbat are connected directly, so no compute
# line is needed for these. For +5V, +12V and 5VSB, the default
# resistors seem to have been used.
compute in3 ((6.8/10)+1)*@ , @/((6.8/10)+1)
compute in4 ((30/10)+1)*@ , @/((30/10)+1)
compute in7 ((6.8/10)+1)*@ , @/((6.8/10)+1)

# nominal voltage +- 5%

# this will not take effect until you run ‘sensors -s’ as root!
set in0_min 1.4 * 0.95
set in0_max 1.4 * 1.05
set in1_min 3.3 * 0.95
set in1_max 3.3 * 1.05
set in3_min 5.0 * 0.95
set in3_max 5.0 * 1.05
set in4_min 12.0* 0.95
set in4_max 12.0* 1.05
set in7_min 5.0 * 0.95
set in7_max 5.0 * 1.05

# Temperatures

# Not sure. temp1 always reads close to what k8temp reports for Core0,
# and to what the BIOS reports as the CPU temperature. temp2 is close
# to what the BIOS reports as the motherboard temperature.

label temp1 “CPU Temp”
label temp2 “MB Temp”
ignore temp3

# this will not take effect until you run ‘sensors -s’ as root!
set temp1_min 30
set temp1_max 75
set temp2_min 30
set temp2_max 75

# Fans

label fan1 “CPU Fan”
label fan2 “Chassis Fan 1″
label fan3 “Power Supply Fan”

# Ignore fans you don’t have
ignore fan2
ignore fan3
ignore fan4

# Ignore vid
ignore cpu0_vid

Don’t forget to run sensors -s as root!

Leave a Reply